Accessory

MMP-ER/ES MODULAR ACTIVE CABLE, XLR (MMP-ER/ES)

Customize your microphone

MSRP $479.95 excl. local VAT
Product ID MMP-ER
For use with hanging mics or low-profile table or instrument mics, the MMP-E Modular Active Cable Preamplifier can be combined with any modular capsule in the d:dicate™ Microphones Series.

It features a high quality preamplifier split into a 12 mm housing and a 3-pin XLR connector. These components attach the capsule to a cable at a length of 3 to 30 meters. It is an ultra-transparent preamplifier with active drive for impedance balancing to reject frequency interference.

It is available with rear or side cable entry.

A wireless version with a MicroDot, the MMP-G Modular Active Cable for d:dicate™, is also available.

To learn more read our Microphone University article: Impedance balancing with Active Drive vs transformer coupled outputs.


Order numbers: MMP-ER, MMP-ES.

Specifications

accessories MMP-ER/ES MODULAR ACTIVE CABLE, XLR (MMP-ER/ES)

Output connector
XLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: - phase
Low-cut frequency, -3 dB
15 Hz
Noise with shorted input A-weighted
0.6 µV
Output voltage, RMS
2.2 V
Output voltage, peak
3.1 V
Type of electronic circuit
Active
THD@1VRMS, 1kHz
< 0.2 %
Dynamic range
131 dB
Output impedance
100 Ω
Minimum load impedance
2 kΩ
Cable drive capability
100 m (324 ft)
Output balance principle
Impedance balancing
Common mode rejection ratio (CMRR)
> 40 dB
Power supply (for full performance)
48 V Phantom power (± 4 V)
Current consumption
3.5 mA
Color
Matte black
Weight
91 g (3.2 oz)
Diameter
19 mm (0.75 in)
Length
3 m (9.8 ft)
Temperature range
-40 °C to 45 °C (-40 °F to 113 °F)
Relative humidity (RH)
Up to 90 %


Loading