Manual

Table of contents

Description
Accessories
Specifications

4055 Kick Drum Microphone

The 4055 Kick Drum Mic delivers the renowned DPA sound, clarity and linear frequency response, both on axis and off axis. The mic captures the clear, true sound of a kick drum, whether it is used in classic, jazz, rock or any other genre. Its unique asymmetric design makes it easy to position, both inside and outside the drum. With its large, robust housing, wind damping foam, specially-designed shock mount the mic is ready to perform on any live stage

Accessories

UA0961 Microphone Holder for Pencil Microphones

Specifications

Polar pattern

Frequency response graph

Directional pattern Open Cardioid

Principle of operation Pressure gradient

Cartridge type Pre-polarized condenser

Frequency response 20 Hz - 20 kHz

Effective frequency range ±2 dB, at 20 cm (7.9 in) 40 Hz - 18 kHz with a 6 dB soft boost at 10 kHz

Sensitivity, nominal, ±2 dB at 1 kHz 2 mV/Pa; -54 dB re. 1 V/Pa

Equivalent noise level, A-weighted Typ. 27 dB(A) re. 20 µPa (max.29 dB(A))

Equivalent noise level, ITU-R BS.468-4 Typ. 39 dB (max. 41 dB)

Distortion, THD < 1% 156dB SPL RMS, 159 dB SPL peak

Dynamic range Typ. 132 dB

Max. SPL, THD 10% 164 dB SPL peak

Rated output impedance 380 Ω

Minimum load impedance 2

Cable drive capability 100 m (328 ft)

Output balance principle Impedance balancing with Active Drive

Common mode rejection ratio (CMRR) > 55 dB

Power supply (for full performance) P48 (Phantom Power)

Current consumption 2.0 mA

Connector XLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: - phase

Weight 241 g (8,5 oz)

Microphone diameter 57 mm (2,24 in)

Capsule diameter 17 mm (0.67 in)

Microphone length 132 mm (5,19 in)

Maximum output voltage, RMS 9.75 V

Polarity +V at pin 2 for positive sound pressure

Temperature range -40°C to 45°C (-40°F to 113°F)

Relative humidity (RH) Up to 90%

Description
Accessories
Specifications